| Solar > Charge Controller |
|
|
|
SOLAR CHARGE CONTROLLER |
|
The solar charge controller uses PWM charging technology, so that as the battery reaches full charge, the PWM pulses slower, gradually tapering off the charge. Pulsing is good for the batteries since it gently mixes the electrolyte, preventing stratification and sulphation. Low voltage disconnect protects the batteries from severe discharge by shutting off loads before the battery voltage drops to damaging levels.
Temperature compensation adjusts the set point voltages according to the ambient temperature. |
| |
|
FEATURES
- Excellent charging algorithm
- Temperature compensated set points
- Adequate protections and indications
- Negligible voltage drops
- Self consumption less than 5 mA
- Offers long life to batteries
- Non-corrosive terminals
- Compact in size and easy to install
|
 |
| |
|
MECHANICAL DRAWING |
|
Charge controllers, which protects battery from over charging and/or excessive discharge, are the essential component of Solar PV system. |
| |
| TECHNICAL SPECIFICATIONS |
|
|
|
Solar Charge Controller3/3 |
Solar Charge Controller3/6
|
|
General |
|
Application |
Solar electrification |
|
Use |
Indoor, battery charging using solar module |
|
Operating temperature |
0°C to 50°C |
|
Storage temperature |
-10°C to 60°C |
|
Charge controller type |
Two step charging algorithm |
|
Battery temperature compensation |
-4mV to -5mV/°C/cell |
|
Solar Module size (Max) |
40Wp |
|
Indications |
Changing and low battery |
|
Electrical |
|
Nominal system voltage |
12V DC |
|
Charging current (Solar) |
3A |
3A |
|
Load current |
3A |
6A |
|
Charge controller efficiency
|
>93% |
|
Idle consumption |
<5mA |
|
Protections |
Against module reverse current flow, reverse battery and overload |
|
Mechanical |
|
Fixing |
Wall mounting with screws |
|
Case |
Injection Moulded Engineering Plastic |
|
Connectors |
Heavy duty terminal connectors |
|
| Note: Specifications subject to change without notice. Check for latest update |
| |
ORDERING INFORMATION |
|
Solar Charge Controller series |
Model |
System Voltage |
Max Module Wattage |
Max Charging Current |
Max Load Current |
Battery Type |
SCC-M0303C |
12V |
40Wp |
3A |
3A |
Flooded |
SCC-M0303D |
12V |
40Wp |
3A |
3A |
VRLA(SMF) |
SCC-M0306A |
12V |
40Wp |
3A |
6A |
Flooded |
SCC-M0306B |
12V |
40Wp |
3A |
6A |
VRLA(SMF) |
|
| |
| |
|
|
